Underside Of Roof Sheathing Is Wet

The ventilation is needed not only for moisture control but also to reduce by 20 40 high summertime attic and roof sheathing temperatures which are bad for roof trusses rafters and the roof sheathing as well as the shingles and underlying waterproofing membrane which can reach 160 180 degrees over an unventilated attic.

Underside of roof sheathing is wet.

Trapped water will boil when the sun heats the roof and the shingles will then have small pits where. This can be caused by the action of fungal growth and molds and the affect they have on the tannins in the wood. Does mold on attic sheathing have to be removed. When moisture condenses on plywood roof sheathing repeatedly or continuously the wood will turn black.

Those often are the underside of the roof. The following picture is of a long standing moisture condition in an attic where much of the roof sheathing has turned black. The osb and in fact any wood panels must be allowed to dry completely depending on how wet the panels are this could be a few days before any roofing material is applied to avoid trapping moisture under the roof material that could cause edge swell and buckling. If the temperature drops below the freezing point often at night after the sun goes down this moisture will freeze.

Mold on attic sheathing. Mold growth on attic roof sheathing is a common issue in cool climates such as the pacific northwest. The presence of mold inside your home even if it. Generally tearing off a roof and roof sheathing and perhaps roof framing to remove mold would not be sensible nor cost justified.

This occurs when the temperature of the sheathing drops below the dew point creating a thin layer of moisture on the substrate. In the vast majority of cases the mold growth is caused by condensation. Installation tips osb roof sheathing the ol sage builder trubord. Mold growing on the sheathing in your attic is a serious problem that shouldn t be ignored.

On going back inside the attic the frost had melted and the underside of the sheathing was wet not so much that it was dripping but enough that it was damp. It is never a good idea to install a roof over wet plywood or any type of roof sheathing. There were also several issues with the intersection of the roofs where the 2 apartments meet.